Main Menu

Body

cabriolet top adjustment

Model: 968, Year:1994, Mileage:60000, Type of use:Street use only
My cabriolet top does not pull tight enough onto the windhsield frame. One side seems to be tighter than the other, the joint on one side rattles over bumps and I do get some leakage by the seal in heavy rain or direct spray while washing. The seal appears to be good (no tears, reasonably soft). I have dismantled the leading edge interior cover to access the twist lug mounting hardware, but found little to no adjustment. Suggestions?

Squeaky 968 Headlights

Model: 968, Year:1993, Mileage:126000, Type of use:Both Street & Track
The headlights on my '93 968 rotate up and down fine but are starting to squeak pretty bad. I would like to lubricate them before something jams up or wears out.Do I have to take the fenders apart to get to the points that need lubrication? What points need lubrication and what's the easiest way to get at them?Thanks!

cab top

Model: 944S2 Cab, Year:1991, Mileage:120k, Type of use:Street use only
Bill,What is the procedure for synching the motors on the cab top? I had to unbolt the top at the hinge points to manually raise/lower the top and now need to reestablish the raising and lowering cycle.Eddie Camm

Body shop in Boston area

Model: 968, Year:1994, Mileage:110,00, Type of use:Street use only
Can anyone suggest a good body shop for a 1994 968 in Boston? My car was involved in a minor accident. There will need to be body work and paint. So far I am considering taking it to one of the dealers to get the work done right. Any preferences on dealers or other suggestions appreciated.

Hood release 944 1990 S2 Cabriolet

Model: 944 S2 Cab, Year:1990, Mileage:28,673, Type of use:Street use only

1988 Sunroof

Model: 944, Year:1988, Mileage:164000, Type of use:Street use only

vin

Model: 944 S2, Year:1990, Mileage:130000, Type of use:Both Street & Track
How do I decode Vehicle VIN's

how to repair rubber on bumper

Model: 944, Year:1987, Mileage:198,00, Type of use:Street use only
Right rear rubber bumper fell off. I cleaned the rusted metal and replaced with stainless steel hex bolts. But, I am unable to find a solution to anchor the bolts. Any suggestions?

Cabriolet top inoperable

Model: 968, Year:1995, Mileage:60000, Type of use:Street use only

Water leaking into rear fender wells

Model: 944S, Year:1987, Mileage:31,000, Type of use:Street use only
I have water leaking into the rear fender wells on both sides. Appears to be coming from rear hatch pin openings but unsure. Water found on top of tail light recess and running into wells. Any ideas on where this coming from without removing rear spoiler?Jack Wilkie

Pages

Subscribe to RSS - Body