Main Menu

1982 911SC Alternator Replacement

Electrical

Vehicle Information: Model: 911 SC; Year: 1982; Body Type: Targa; Total Mileage: 169000;

I recently purchased a new Bosch alternator for my car. When I went to install it I noted that the alternator body wasn't as deep as the original Valeo alternator. After installing it into the fan shroud I noticed that the fan sat back further into the fan shroud. After installing the alternator fan shroud assembly into the engine I couldn't get the alternator belt to stop rubbing on the fan shroud because of the alternator sitting back further than the original. I therefore decided to install a new Valeo alternator. Turns out that the Valeo had the same problem. The only way I could get it to line up properly so the alternator belt did not rub was by putting 2 nuts on the inide of the alternator studs and then mounting it into the fan shroud. Is there some sort of spacer that should be used to alleviate this problem?

You must log in to view answers associated with technical questions. Join PCA to participate in our community.
0
No votes yet