Can I remove the front transmission bracket of A 96.30 AWD tiptronic.

I used the AGA removal installation tool to remove the original mount then inserted the rennline replacement mount.  I got this mount in 3/4ths of the way in and its now stuck.  I noticed this bracket is srewed on the transmission housing and looked online for diagrams on this.  I found limited diagrams that showing the bolt that holds the yoke and 4 torx screws.  A better diagram is seen in the AutoAtlanta.com website for part number 996321056X showing bearings retaining clips and the drive gear with other bearing caps.  I would prefer to avoid removing the entire transmission to remedy this problem and would like advice if I can simply remove this bracket easily so I can use my shop press.