Main Menu

Rear damage frame/monococque pull points

Body and Interior

Vehicle Information: Model: 911; Year: 1985; Body Type: Coupe; Engine (type, size, modifications): 3.2; Total Mileage: 104000;

Hello,Can you tell me where specifically I should weld 3/16 angel iron on my rocker panels as no one in my city has Porsche clamps or a cellet. I need to pull a .5 inch up/back/out. I was told the best way to not damage the car further is no heat,no attaching to Torsion tube covers and to weld on these angel irons. Should I use 1" by 1" or 2" by 2"? Where should I start and where should I stop (start at front of bottom of door and end at back of door?Thank you very much,Mike506.644.9702

You must log in to view answers associated with technical questions. Join PCA to participate in our community.
0
No votes yet